|
3.Enter the jbexercisecommand at the prompt and specify the control port and
the device type.
The control port for SCSI autochanger models is typically expressed in the format /
dev/scsidev@n.n.n. You can obtain the exact control port pathname from the response
displayed by the jb_config command script:
These are the SCSI Jukeboxes currently attached to your system
1) scsidev@1.2.0: DLI Libra Series
2) scsidev@0.2.1: Quantum DLT/Digital DLT
For example, the following command runs the jbexerciseprogram on the
Quantum DLT/Digital DLT autochanger detected by the jb_configscript
# jbexercise -c /dev/scsidev@0.2.1 -m "Quantum DLT/Digital DLT"
See the appendix "Command Line Reference" in the Solstice Backup 5.1
Administration Guideor refer to the jbexercise(1m)man page for additional
information on the command options available for the jbexercisecommand.
Caution - After you install, configure, and test the autochanger, enter the enabler
code for the Backup Autochanger Software Module according to the instructions on
your enabler certificate. Be sure to register and authorize the Autochanger Software
Module; otherwise, the software will disable itself 45 days after you enter the
enabler. See "Enabling and Registering Backup" on page 45 for instructions.
|
